User Tools

Site Tools


wiki:flash-from-uboot

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
wiki:flash-from-uboot [2013/10/21 17:34]
federicov
wiki:flash-from-uboot [2019/05/28 11:22] (current)
Line 1: Line 1:
-** U-boot configuration ​**+====== ​U-boot configuration ​======
  
 The required components to successfully boot the board are: the boot-loader (u-boot), the kernel (Linux), the file system (rootfs) and the Atheros calibration raw file (ART). This page describes how to write these components on the internal SPI Flash memory by using u-boot and the TFTP protocol. ​ The required components to successfully boot the board are: the boot-loader (u-boot), the kernel (Linux), the file system (rootfs) and the Atheros calibration raw file (ART). This page describes how to write these components on the internal SPI Flash memory by using u-boot and the TFTP protocol. ​
Line 21: Line 21:
 It is not mandatory to write every components each time, you can write only the one that you need. Following, the commands to write each component in the correct place. It is not mandatory to write every components each time, you can write only the one that you need. Following, the commands to write each component in the correct place.
  
-** U-Boot procedure to flash **+===== U-Boot procedure to flash ===== 
  
 * u-boot * u-boot
wiki/flash-from-uboot.txt · Last modified: 2019/05/28 11:22 (external edit)